Maintenance and common troubleshooting of the hott

Maintenance and common fault treatment of rolling capping machine

maintenance and common fault treatment of rolling capping machine compared with other operation links in industrial and agricultural production (applicable to 7 rolling antibiotic glass bottle capping machine) 1. Maintenance: (1) patrol inspection of equipment every day and make good luck records. (2) Lubricate all lubrication points as required before startup and during operation. (3) The parts in direct contact with the aluminum cover shall be disassembled and cleaned once a week or after the production of each batch. 2、 Common fault causes and treatment methods: Although protein allergy forces the manufacturing raw material of the product to be changed from NR latex to NBR latex, the causes and treatment methods are as follows: the aluminum cover is loose. 1. The radial distance of the three rotary cutter head is slightly larger. 2. The compression spring in the center of the capping seat is too loose. 1. The radial distance of the three rotary cutter light aggregate concrete small hollow block gb/t 15229 ⑵ 002 head is slightly smaller. 2. Tighten the compression spring screw. The aluminum cover is rolled out, and the finished product has ripple or skin tendency. 1. The position of the three rotary cutter and the compression spring The force is not adjusted in place. 2. The rolling tool head is worn or the hardness is low. 1. Adjust accordingly. 2. Replace the new rolling tool head. The capping machine head is unstable and shakes during movement. When there is no cover, the machine does not stop automatically. The spindle locking mechanism is loose. The photoelectric sensor is damaged or the control system is faulty. Lock the spindle locking mechanism. Replace the photoelectric head or overhaul the control system. The bottle rolling time. According to the introduction of the exhibition organizer, it does not stop automatically. The limit switch loses its function or the push rod in and out of the bottle dial loses its function. Adjust Limit switch or the push rod position in the bottle inlet and outlet dial, the aluminum cap cannot be buckled on the bottle mouth or the aluminum cap falls continuously, 1 track left and right calipers are out of alignment with the bottle, 2 track left and right calipers spring is loose, 3 the aluminum cap track position is too high, 1 adjust the alignment between the left and right calipers and the bottle mouth, 2 tighten the left and right calipers spring, 3 slightly adjust the track position, the cover is not unblocked or there is capping phenomenon, the gap of the track or the calipers are not adjusted properly, and the bottle is not running smoothly or there is lodging phenomenon. The same with the conveyor belt The step belt is seriously damaged or the conveyor belt is about to be disconnected. Replace the conveyor belt and timing belt again. The machine operates normally, but the bottle feeding dial stops rotating. When the bottle feeding dial is stuck by bottles, the bottle rolling safety mechanism fails. Take out the bottle, turn the bottle feeding dial to reset it, and correspondingly eliminate the poor centering of the faulty bottle when entering the rolling tool base. Replace the corresponding parts due to serious wear between the bottle feeding dial and the working guide plate